Apex Radon Solutions Before & After Photos
Click on a photo to enlarge.
Two-Point Radon Mitigation System Planned for East Canaan Home
Before
The home currently has an elevated radon level of 10.8 pCi/L and no active radon mitigation system. The unfinished basement provides access for installing the two extraction points.
After (Planned Work)
A two-point radon mitigation system will be installed in the unfinished portion of the basement. One pipe will exit through the left side of the home, with the second extraction point located near the finished-space doorway by the shelves. A tall ladder will be needed to complete the exterior piping.
Premium Radon Mitigation System with Additional Extraction Point Installed
Before
The home had elevated radon levels with no mitigation system in place and limited airflow beneath the slab.
After
A premium radon mitigation system with two extraction points was installed, with piping routed to an exterior fan and vented above the roofline for effective radon reduction.
Radon Fan Replacement and Extraction Pipe Cleaning in Washington
Before
The existing radon fan was approximately 29 years old and making noticeable noise. The exterior photos show the existing fan and piping, including the connection that needed attention.
After
The old fan was replaced, the extraction piping was cleaned, and the clamp above the fan was re-secured to support a stable connection.
Radon Fan Replacement in Washington
Before
The existing radon mitigation fan had gone approximately ten years without service. It was humming but was switched off, leaving the system in need of attention.
After
The radon fan was replaced to restore system operation and support continued radon reduction. Periodic system checks and radon testing are recommended to confirm that the system continues to perform effectively.
Three-Point Radon Mitigation System Installed in Greens Farms
Before
Built in 1920, this home tested at 17.0 pCi/L, significantly above the EPA’s recommended action level of 4.0 pCi/L. The property has two foundation areas: a small basement and a crawl space, with dirt and rock beneath the home. The mitigation design needed to account for both foundation areas when establishing the extraction points.
After
A three-point radon mitigation system was installed using an Eagle Extreme fan. The extraction points and piping were configured to address the home’s foundation layout, with the exterior pipe routed along the right side toward the back of the house. The installation was completed without unusual conditions or changes to the original plan. Follow-up testing can help confirm the system’s effectiveness.
